Black Speckles all over the sheet

Hello All,

We were having an issue with our Yellow developer so we cleaned the manifold and such. Went to print this morning and am getting black speckles all over the sheet. I look at them under a loop and they look like fused droplets. I understand the cleaning of the Yellow should not have created this issue but it was the only extraordinary maintenance done. See photo attached. Any thoughts?

Thanks!!

 

Try this >>

Diagnostics >> Dc0106 Job Exerciser >> Print engine >> Test Pattern >> 311_SRA3_DeveloperRecvry

Set your number of sets to 100 x 1 set double sided. Add stock you want to waste and send it to the stacker.

Print your job again.

See if that works...

 

Thank you for the quick response. However, there is no 311_SRA3, I did find a Developer Recvry for 12 x 18 trying to run that at this time.

 

I run an Igen 150... I remember the number changed from Igen 4 to 150... I think it was 111 on the Igen 4.

This should fix it. It if semi fixes it run another 100 sheets.

Yeah I'm from Australia so the measurements and diagnostic numbers will likely differ on your rip.