Thanks LLS. Running smooth now with dead register, no gripper marks Your guidance was right on the mark Best Regards Wayne
So you must be getting doubling/slurring too I imagine. It sounds like a transfer gripper problem, of could be thrust bearings if it is lateral....
Is it sheet register, or distortion? If diagonally, it may be a different issue. Assuming you have marks on your sheet edge, are they bouncing?
I agree with Tom, at least for the initial phase. As a commercial printer, I can tell you that just having the printing device is only a small...
Managed to set the bolt. I had to remove the bracket for the swing arm stop screw setting to gain access to the grub screw. (I did not alter the...
Thanks Again... That makes sense. I do not really want to take the swing arm out, so hope this will do it. Now to find a way to get access to...
Thanks LLS, Thanks LLS I found the 17mm eccentric and it is loose. I was short on time today, but did manage to locate it. I had a difficult...
Thanks LLS Will do. Is this bolt simply accessed from under the feeder, or is it between the frame and side cover?
Right, That was why I was looking for some help from someone who knows the proper procedure. We do have some fairly capable people here and have...
We are having a similar problem with our GTO 52. Swing Arm to impression cylinder transfer seems to be out of sync. We have tried adjusting the...