Changing the plate length on the DPM 2340

Discussion in 'Platemaking' started by howardppolenberg, Aug 16, 2010.

  1. howardppolenberg

    howardppolenberg New Member

    Joined:
    Aug 2010
    Messages:
    1
    Location:
    Ocean County Vocational Technical School, Brick, N
    I need to shorten the length of the plate for the TokoR2 by 3/8 inch.

    I was shown the process when the school purchased the palte makler 5 years ago, I never had to mess with the settings but now would like to adjust he plate output to match the drum size of the perss.

    ANy ideas.

    Thanks
     
  2. Uncle Vinny

    Uncle Vinny New Member

    Joined:
    Mar 2011
    Messages:
    4
    Location:
    Cincinnati, OH
    I don't know if you got your answer yet, but here it is. First turn off the inputs, which is the icon with the stop light and red arrow. Next go to the Page Setup Manager, the icon is I think the 5th one from the left it has a yellow page or you can go under "PrintersRIP" pull down to Page Setup Manager". Highlight the Page Setup you wish to change and click edit. In the page setup window go to "Configure Device" and depending on what software version you have with say "Plate Height" or "Fixed Feed Length". Enter the length you want and ok out of everything and restart the inputs with icon of the green traffic light.
    Hope this helps
     
Loading...