2 Color Offset Press 4+ Color Offset Press Direct Imaging Printing Press Digital Printing Press Color Copiers and Color Laser Printers Finishing Equipment Inkjet and Art Printers
2-Color Offset 4+ Color Offset Direct Imaging Digital Press Color Copiers Finishing Inkjet & Fine Art
+ Reply to Thread
Results 1 to 4 of 4
  1. 02-22-2012 03:50 PM #1
    auchprinting
    auchprinting is offline Member
    Join Date
    Dec 2010
    Location
    Glenside, PA, USA
    Posts
    30

    Manroland 202 - Remove no operator side panel to access dampener motor - bottom unit?

    Any instructions? Removal of forward and sideward controls on side panel to remove side panel on non operator side.?
    Reply With Quote Reply With Quote  
  2. 02-22-2012 04:57 PM #2
    spike
    spike is offline Senior Member
    Join Date
    Apr 2011
    Location
    new york
    Posts
    138

    these are pined in place once you remove pins then you can take off up /down and sideways controls
    just make sure you center the gauges before you take off
    Last edited by spike; 02-22-2012 at 04:58 PM. Reason: incorect sprlling
    Reply With Quote Reply With Quote  
  3. 03-05-2012 10:28 AM #3
    auchprinting
    auchprinting is offline Member
    Join Date
    Dec 2010
    Location
    Glenside, PA, USA
    Posts
    30

    I have removed one pin on the front to back adjustment. Now there is a screw underneath the dail which will not move. Any suggestins?
    Reply With Quote Reply With Quote  
  4. 03-05-2012 05:12 PM #4
    spike
    spike is offline Senior Member
    Join Date
    Apr 2011
    Location
    new york
    Posts
    138

    you need to take off both dials remove all the allen screws that hold the cover on/ the the cover should slide off the shafts where the dials were there may be one allen that holds the steel plate on remove it
    Reply With Quote Reply With Quote  
« Maintenance | Manroland 202 - How to set water dampeners »

Similar Threads

  1. Manroland 202 Plate Punch
    By auchprinting in forum Man Roland Printing Presses
    Replies: 9
    Last Post: 11-16-2011, 11:01 AM
  2. Manroland 202 Service
    By auchprinting in forum Man Roland Printing Presses
    Replies: 2
    Last Post: 09-02-2011, 09:19 AM
  3. Manroland 202 --- Press will not run
    By auchprinting in forum Man Roland Printing Presses
    Replies: 10
    Last Post: 08-30-2011, 05:09 PM
  4. JR205 Encoder for Actus Dampener Motor
    By klecman in forum Komori Printing Presses
    Replies: 4
    Last Post: 04-25-2011, 04:41 AM
  5. Manroland 202 Parts
    By auchprinting in forum 1-Color and 2-Color Offset Presses
    Replies: 0
    Last Post: 12-15-2010, 12:30 PM