KORD 64 Schematic/wire diagram needed badly

Discussion in 'Heidelberg Printing Presses' started by DLB, Mar 21, 2013.

Tags:
  1. DLB

    DLB New Member

    Joined:
    Mar 2013
    Messages:
    2
    Location:
    va
    Hi, I was in the middle of a job and after I lowered the delivery all the way down the press would not power up at all.
    Any ideas would be appreciated especially the wiring diagram, mine was in the door to electrical box but was drenched in oil so it is unreadable.
     
  2. DeDe

    DeDe Member

    Joined:
    Mar 2011
    Messages:
    15
    Location:
    Asia
    may be your delivery pile switch is stuck after you lowered down the pile.

    Just check it out carefully....if possible disassemble the switch and clean the contact points....then you're done.....

    Good luck buddy....!!!
     
  3. DLB

    DLB New Member

    Joined:
    Mar 2013
    Messages:
    2
    Location:
    va
    It's not that simple DeDe, The switch is buried deep inside the press.
    I can hear it click when I lower the pile all the way down but cannot even see where the wires are that go to the switch.
    The stack has not been lowered all the way down in years so the switch is not needed.
    I need to find out how to disable it from the other end.
    I need the wiring diagram so I can see where the switch is connected in the power unit, or need to find out which relay
    to disable.
     
  4. DeDe

    DeDe Member

    Joined:
    Mar 2011
    Messages:
    15
    Location:
    Asia
    here is the scheamatic buddy.....

    are you happy now.....????...... ;-)

    good luck

    -DeDe-
     

    Attached Files:


  5. superteto

    superteto Previous User

    Joined:
    Feb 2014
    Messages:
    48
    Location:
    no
Loading...