Heidelberg TOK - Feeding Problem

I have a Problem when i feed sheets through the TOK, Its keeps folding 1 corner of the sheet, see picture below.



Any help or suggestions?

Thanks in Advance

Billy

 

The paper must be catching on something as its passing from the infeed to the impression / delivery grippers.

 

ive check and check but i cant seem to figure out where it could be catching, also another problem i had today is 80gsm bond paper keeps getting stuck to the blanket.

 

Are the infeed rollers pushing the sheet into the grippers ok......have you altered / changed the feeder timing positon.

 

not sure how to do that to The roller feeders. is the timing set with the 2 sheet trip

 

no ...... you should have a separate adjuster for the timing.

 

Can you tell me how or where this is?

 

Hi i have this problem to sometimes if you move your front lays either way ut should help the problem for the time being but it is one of your grippers not set properly thats all

 

Try adjusting the side blowers and pile height. The press may need new air filters and vanes.

 

I have a TOK/TOM repair manual and I may be able to email you or send you those pages if you like.

 

Hi, this is my first post, so hope it is of some use. I would say your air flow is set to low, and/or the side copper sheet seperators are set too strong into the sheet. I have never heard of adjustable timing on a tok, but you learn something new everyday. good luck mate, and let us know how you get on.

 

try putting a sheet flapper on that area on your feed board to hold the sheet down as it goes into the infeed grippers,or create your own flapper w/a piece of.010 stock.

you can also try to run sheet of center on feed board and moving your plate lateral to recenter print.

try and locate the delivery gripper thats causing the problem and readjusting,unless is the infeed grippers thats causing your dilemma.good luck

 

the TOK/TOMsheet not so clearly

 

Thanks for all, the suggestions, but when i had Egineer out, it was the timing.

 

How did he adjust the timing bud? just out of curiosity?

 

He took all the side panels off, and adjusted some wheel, took him about 2.5 hours to do, apparently is was well out?!

Am looking to buy a Printmaster QM46-2 2004 Model, Any Suggestions on this?

Can i do small runs of 1-2K Process work?
Whats the registration like?

 

billy, how much are you looking to spend would you consider a GTO 4 colour 46 1981 if i can get ti for the right price?

 

I doubt i can afford a 4 Colour, I have my eyes on a QM46-2 2004 Model Asking price is 6000, I have negotiated part ex with my hamda CD480 and 4000 cash

 

Ok MAte i see, no i dont think ill get it that low lol

 

I need TOK USER MANUAL, please send me to my email address barry@splashmedia.co.tz