I have a Heidelberg QMDI 46. From the operator side to the non-operator side about 4 inches from the trailing edge, there is a yellow line showing up. It is not on the plate and we have taken the rollers out and cleaned them by hand, but the line is still there. Any ideas?

here is a few suggestions, if these dont work i have more.
1st try backing the 3rd unit form roller off the plate, this usually works when you have toning on any unit. or add body gum to the ink but that changes your color allot. make sure you have enough water in your cooling unit.
keep room temp at 70-72 degrees.
drop temp down on press 2 degrees.
i run my roller setting to a 1/2 degree smaller to the plate them what h-berg tells you.

Hi,

Check your ink roller clutch positions.

Regards.

Hi Mrheidelberg,

I'am not sure I understand how to check ink clutch position. Where are the ink clutches? This is something entirely new to me and I am real interesting this.

Thanks

Hi,

You can check them by the large round discs with a lever arm attatched(1 per unit) with a drilled hole towards the outer edge, when you open up the covers on the operator (computer) side. Inch machine to 0 degrees (SF60)
The drilled hole should be at these approx positions:-

PU1 6 O'clock
PU2 6 O'clock
PU3 12 O'clock
PU4 7 O'clock

Regards.