Polar Mohr 115

I am looking at a Polar Mohr 115ED, 1995 model. Does anyone know the difference between the ED and the EL models? Also, would anyone have specs on the cutter, weight, dimensions etc. I comes with the two air tables.

Thanks, Dan

 

Hi Dan,

E/ED machine was the generation(1995-2005) before X/XT(2005 till now) both of them equiped with a LCD monitor but the EL(eltromat memory) was the generation(1960-1970) quite a long time ago which equiped with magnetic tapes and heads for programming.

Please visit http://www.welvin.com or welvin.no-ip.org for any polar spare parts or further enquiries.

email to: welvin@welvin.com or simon@welvin.com

Polar 115 E / ED with Standard Equipment :-

Cutting width 115 cm/451/4“

Clamp opening 16,5 cm/61/2“

Feed depth 115 cm/451/4“

Power (main drive) 4 kW/5,5 H.P.

Weight, net 3200 kg/
(without special equipment) 7055 Ibs

Width, without side tables 233/91+3/4“

Width, with side tables 265 cm/104+3/16“

Length 254 cm/100”

Height 165 cm/6415/16“

Front table length 71,5 cm/28+1/4“

Table height 90 cm/351/2“

Clamp pressure, min. 150 daN*/330 Ibs

Clamp pressure, max. 4500 daN*/9920

Knife thickness 13,75 mm/9/16“

Grinding reserve 1), max 6 cm/23/8“

Smallest cut,
without false clamp plate, min. 2,5 cm/1“
with false clamp plate, min. 9 cm/31/2“

Backgauge speed 0–30 cm/sec

Static floor load 1100 daN/m2/
225 Ibs/sq.ft.

Contact area load 1,6 daN/cm2/
23 Ibs/sq.ft.

Dynamic surcharge 20 %

Supply voltage
(three-phase) 190-240 V
Fusing25 A

Supply voltage
(three-phase) 340-440 V
Fusing20 A

Supply voltage
(three-phase) 500-600 V
Fusing (with series transformer)20 A

1) only on standard equipment *daN = kp

 

Thanks, Dan