|2-Color Offset||4+ Color Offset||Direct Imaging||Digital Press||Color Copiers||Finishing||Inkjet & Fine Art|
Welcome to the Color Printing Forum
a forum for Offset Press and Digital Printing information
Please Login at the top right or Register. The Color Printing Forum is a forum to discuss offset press printing, direct imaging offset presses, digital production presses, short-run digital printing, fine art inkjet or giclee printing, and finishing equipment. Topics range from selection of new printers, printing press, and finishing equipment to adjustment, troubleshooting, optimization, and maintenance of existing printers and presses to media and finishing.
New members are encouraged to Please Register Now - it's free!
All printing equipment discussion, questions, tips and tricks are welcome. And we would like to thank experienced pressmen in advance for taking the time to share your printing experience with the Color Printing Forum community. Register »
I am looking for a trimmer Polar 72CS electrical and electronical diagram.
I have problem with power supply and more........
Someone with no experience trying to make repairs, and something very bad result.
Please help..... Thanks guys
Last edited by simon yeung; 08-21-2012 at 10:51 PM.
do u have any idea about polar 72 clutch dc voltage. now when we press the switch knife is not working
Does the clamp work normal?
Does the machine has a safety bolt?
Do you have any idea about the machine number?
And how many do you charge your customer if we help you free of charge?
yes , clamp is working.
I am not sure about safety bolt
machine number is 4951E49
polar eltromat 72 is the old one who is used by small printing people now. so there is no way to charge much.
if we press on relay 1 and 2 on card 24 simultaneously the clutch is working
In your spare part book on page 13 is a safety bolt.
In the machine it is behind the sheet metal cover above the gear box. There is a switch. In your drawing this switch is called b.SB. Maybe this switch has too much resistance.
The machine number is not correct. I don’t know which drawing I should check