Heidelberg QM 46 2 Problems!!! 13-01 15-04 15-01

Discussion in '1-Color and 2-Color Offset Presses' started by waynek, Dec 10, 2014.

  1. waynek

    waynek New Member

    Joined:
    Dec 2014
    Messages:
    2
    Location:
    St. Louis, MO, USA
    Hoping someone can help as finding someone to work on a Heide in this area is just short of impossible.

    Press was running great no issues, go to turn it on one morning and it had a 15-01 TRM MRK fault code.

    Bought a used TRM MRK board assembly and plugged it in, did not change or fix the problem so we sent the board back.


    Machine stayed off for a week or so, turn it on today and now the 15-01 code has vanished?.... and is replaced by a 13-01 emergency stop code and a 15-04 safety circuit code.

    We have traced and looked at as much of the safety circuit as we can, and cant seem to find any issues. I am also concerned that the 15-01 code will come back.

    Any help would be great. Thanks - Wayne
     
  2. STW100

    STW100 Senior Member

    Joined:
    Mar 2010
    Messages:
    99
    Location:
    DENVER, CO.
    13-01 just means that the E-stop button on the main panel is pushed down! 15-04 is one of those odd codes. It is stating there is an issue with on of your guard switches. Most of the time it is just a guard not quite closed all the way or a switch sticking. I would open and close all the guards! note if your door is loose this is the most common location. When the door is closed give it an extra push at the hinge side!
    If you are still having issues you are welcome to give me a call & will try to help!
    720-285-9485 ipsqm46.com
     
  3. waynek

    waynek New Member

    Joined:
    Dec 2014
    Messages:
    2
    Location:
    St. Louis, MO, USA
    STW100 we have checked and tested the e-stop switches and the entire safety circuit to make sure the safety switches were operating corectly. I may give ya a call tomorrow. Thanks!
     
Loading...